Epitalon comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2025-11-22. Where a claim depends on a specific study, the study is described rather than over-claimed.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Freeze-dried epitalon is normally kept at minus twenty degrees Celsius in a sealed, desiccated container, protected from light. Short excursions at ambient temperature during shipping are generally tolerated, but repeated warming and cooling cycles encourage moisture uptake, which shortens shelf life. Once dissolved, the peptide is far less stable than the solid: aqueous solutions are subject to hydrolysis and to deamidation at the aspartate and glutamate residues. Working solutions are therefore held refrigerated and used within days, and repeated freezing and thawing of the same vial is best avoided.
Identity and purity are checked by reversed-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, where the peptide bond absorbs. Mass spectrometry confirms the expected mass and reveals whether truncation products or adducts are present. Acid hydrolysis followed by amino acid analysis gives the residue ratio, which should approximate one alanine, one glutamate, one aspartate and one glycine. Counter-ions such as acetate or trifluoroacetate remain in the dried product and lower net peptide content, so a stated purity figure on a label does not by itself describe how much peptide a vial holds.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. It was designed at the St. Petersburg Institute of Bioregulation and Gerontology as a short, chemically defined analogue of epithalamin, a fraction obtained from bovine pineal tissue. Small peptide bioregulators of this type formed a long-running line of work there from the 1980s onward. Because the molecule is produced by solid-phase synthesis rather than extraction, its composition is exact and its purity can be measured directly.
The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.
Animal and clinical reports appear mainly in Russian-language journals from the 1990s and 2000s, covering endpoints such as melatonin rhythm, lifespan in aged rodents, and retinal function. Many of these papers involve small groups, lack blinding or placebo comparison, and are difficult to retrieve through indexed databases. Review articles published in English generally summarise the claims without reanalysing the underlying data. Because no large randomised trial exists, the clinical importance of these reported effects stays unresolved and is properly described as an open question.
No national medicines regulator has approved epitalon as a therapeutic product. It is generally distributed as a research chemical, and in some jurisdictions selling peptides for human consumption without approval is restricted or prohibited. Certificates of analysis accompanying commercial material vary in which tests are performed, and independent verification of identity and purity is uncommon. Statements about anti-ageing or disease-prevention benefits on vendor pages are marketing claims rather than regulatory findings, a distinction that shapes how the compound is discussed in scientific and popular sources alike.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
There are several other bioprinting techniques which are less commonly used. Droplet-based bioprinting is a technique in which the bioink blend of cells and/or hydrogels are placed in droplets in precise positions. Most common amongst this approach are thermal and piezoelectric-drop-on-demand techniques. This method of bioprinting is often used experimentally with lung and ovarian cancer models. Thermal technologies use short duration signals to heat the bioink, inducing the formation of small bubbles which are ejected. Piezoelectric bioprinting has short duration current applied to a piezoelectric actuator, which induces a mechanical vibration capable of ejecting a small globule of bioink through the nozzle. A significant aspect of the study of droplet-based approaches to bioprinting is accounting for mechanical and thermal stress cells within the bioink experience near the nozzle-tip as they are extruded.
When the B cells get activated, class switching can occur. The class switching involves switch regions that made up of multiple copies of short repeats (GAGCT and TGGGG). These switches occur at the level of rearrangements of the DNA because there is a looping event that chops off the constant regions for IgM and IgD and form the IgG mRNAs. Any continuous looping occurrence will produce IgE or IgA mRNAs. In addition, cytokines are factors that have great effects on class switching of different classes of antibodies. Their interaction with B cells provides the appropriates signals needed for B cells differentiation and eventual class switching occurrence. For example, interleukin-4 induces the rearrangements of heavy chain immunoglobulin genes. That is IL- 4 induces the switching of Cμ to Cγ to Cκ
3-phosphoglycerate can be separated and measured using paper chromatography as well as with column chromatography and other chromatographic separation methods. It can be identified using both gas-chromatography and liquid-chromatography mass spectrometry and has been optimized for evaluation using tandem MS techniques. 2-Phosphoglyceric acid Calvin-Benson cycle Photosynthesis Ribulose 1,5-bisphosphate
Sources: en.wikipedia.org
Cardona completed his PhD at the University of Barcelona (2000–2005), where he studied developmental biology. He then undertook postdoctoral research on Drosophila neuroanatomy at UCLA (2005–2008). Between 2008 and 2011, Cardona was a Group Leader at the Institute of Neuroinformatics, jointly run by the University of Zurich and ETH Zurich. During this period, he developed computational and image-processing methods for neural circuit reconstruction and co-founded two influential open-source platforms that have become widely adopted in the neuroscience community. Cardona joined the Howard Hughes Medical Institute (HHMI) Janelia Research Campus in 2012, serving as Group Leader until 2019. In 2019, he was appointed Programme Leader at the MRC Laboratory of Molecular Biology and Professor at the University of Cambridge, where he leads research on whole-brain connectomics, circuit development, and structure–function relationships in neural systems.
A titration curve for a diprotic acid contains two midpoints where pH=pKa. Since there are two different Ka values, the first midpoint occurs at pH=pKa1 and the second one occurs at pH=pKa2. Each segment of the curve that contains a midpoint at its center is called the buffer region. Because the buffer regions consist of the acid and its conjugate base, it can resist pH changes when base is added until the next equivalent points.
Agonists PACAP-38 (endogenous peptide agonist, full length version) - also activates other receptors VIP, GPR55 and MRGPRX2 and the Secretin receptor. PACAP-27 (endogenous peptide agonist, shorter fragment which retains activity) Antagonists PACAP(6-38) - N-terminal truncated version of the endogenous peptide agonist which acts as a potent PAC1 antagonist BAY 2686013 PA-915 "VIP and PACAP Receptors: PAC1". IUPHAR Database of Receptors and Ion Channels. International Union of Basic and Clinical Pharmacology. Human ADCYAP1R1 genome location and ADCYAP1R1 gene details page in the UCSC Genome Browser. This article incorporates text from the United States National Library of Medicine, which is in the public domain.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
The solid is kept cold, dry and dark, typically at minus twenty degrees Celsius, in a sealed container with desiccant. Dissolved material is kept refrigerated and used promptly. Freezing and thawing a solution repeatedly is avoided because it accelerates degradation.